Filter
Top Products
5
L.E.D. light
(batteries not included)
Installation Of Your Golden Power Lift Chair
Models: PR-501M26, PR-501L26, PR-501T28
1. Install two 9 volt alkaline batteries in the inline battery holder as shown. The
battery holder is zip tied (white) to the rear of the metal frame. Remove zip tie,
extend the cable under and out behind the chair.
2. Remove the transformer from the transformer box, install two 9 volt batteries
and plug the chair into a 115-120V 60Hz A.C. as shown in steps 1 and 2 on page 4.
3. Pull the hand control out of the magazine pocket and secure the cord into the
quick release cable clamp located above the pocket on the arm of the chair.
4. Back installation: Press the down arrow on the hand control until the footrest
is about parallel to the fl oor. This will expose the back brackets at the rear of
the chair.
5. Slide the back down between the brackets until the threaded studs on the back
slip thru the holes in the brackets as shown.
6. Thread the fl ange lock nuts onto the studs and tighten securely using the
supplied wrench or a 7/16" box wrench. Return the chair to the seated upright
position by pressing the up arrow on the hand control.
7. Attach the bottom of the outside back to the Velcro on the arm cross rail.
8. Place the chair in the desired position in the room, leaving the chair a safe
distance from the wall. See distance chart on page 4 for the proper distance
from the wall and corners.
9. Adjust the leg levelers on the bottom of the chair if necessary. Some high pile
carpets can obstruct the footrest operation by rubbing against it. Adjust the
levelers to a height above the pile.
P
A
T
E
N
T
E
D