Filter
Top Products
L.E.D. light
L.E.D. light
From motor
To outlet
115-120V A.C.
DC Power
Bottom view of
Transformer
Transformer
Plug
Install two 9 volt batteries
in transformer for battery
backup (See page 7)
(batteries not included)
3. Place the chair in the desired
position in the room, keeping it 17"
away from the wall. If placing the
chair into a corner, keep it 17" from
the wall as shown. See distance
chart below for your model.
Wall
Side
View
Corner
Top
View
17"
17" 17"
Distance Required From Wall When Reclined
Model Number Wall Corner Model Number Wall Corner
4. Adjust the leg levelers on the bottom of the chair if necessary to level the chair.
Some high pile carpets can obstruct the footrest operation by rubbing against
it. Adjust the levelers to a height above the pile.
5. Slide the hand control from between the back and arm out toward the back of
the chair. Secure the cord into the quick release cable clamp located above the
magazine pocket on the arm of the chair.
4
Installation Of Your Golden Power Lift Chair
Models: PR-200, PR-355M, PR-355L, PR-359M, PR-359L, PR-401,
PR-410, PR-501JP, PR-501S, PR-501S-23, PR-501M, PR-501L, PR-501T,
PR-643, PR-747, PR-751TY, PR-752, PR-906
1. Remove the transformer from the transformer box (located behind the lower
outside back).
2. Plug the transformer into a 115-120V 60Hz A.C. outlet and connect the power
cable from the chair into the transformer as shown. Power cable is located under
the chair attached to the motor with white zip tie. Remove zip tie, extend the
cable under and out behind the chair.
PR-200 11 in. 11 in.
PR-355M 17 in. 17 in.
PR-355L 18 in. 18 in.
PR-359M 17 in. 17 in.
PR-359L 18 in. 18 in.
PR-401 17 in. 17 in.
PR-410 19 in. 19 in.
PR-501JP 17 in. 17 in.
PR-501S 17 in. 17 in.
PR-501S-23 17 in. 17 in.
PR-501M 17 in. 17 in.
PR-501L 18 in. 18 in.
PR-501T 19 in. 19 in.
PR-501M-26D 17 in. 17 in.
PR-501L-26D 18 in. 18 in.
PR-501T-28D 19 in. 19 in.
PR-643 18 in. 18 in.
PR-747 18 in. 18 in.
PR-751 18 in. 18 in.
PR-752 19 in. 19 in.
PR-906 6 in. 6 in.
P
A
T
E
N
T
E
D