Filter
Top Products
Next, we must verify that the SPA-2000 has a valid IP Address:
1. Pick up the phone connected to Phone 1 of the SPA-2000 and dial ****. You will hear
a voice prompt saying "Sipura configuration menu: please enter option followed by
the pound key, or hangup to exit".
2. Dial 110#. The system will now read back the IP address of your SPA-2000. Please
write it down.
If the IP is 0.0.0.0, your SPA-2000 does not have a valid IP address. In this case
you need to:
1. Hang up the phone, unplug and re-plug your SPA-2000 power cord.
2. Wait 2 minutes, and check the IP again.
3. If you still get 0.0.0.0, there can be two reasons for this:
a. Your DHCP Server is not assigning an IP address to the SPA-2000 (in which
case you should contact your network administrator or ISP for assistance).
b. Your network does not have a DHCP server or you have purchased a Static
IP Address for the SPA-2000 from your ISP. In this case, please proceed to
Manually Assigning a Static IP Address below, otherwise skip this step.