Filter
Top Products
12
V3299pr-0920
• Remove the #8-18 x ⅞ " screw from the battery
retainer. Lift to remove the battery retainer from
the vehicle.
• Place the Power Wheels
®
6 Volt (4.0 Amp/Hr.) battery
in the battery compartment. Make sure the battery
connector extends toward the rear of the vehicle.
• Replace the battery retainer over the battery. Insert the
#8-18 x ⅞ " screw through the battery retainer and into
the vehicle. Tighten the screw.
• Locate the lock fasteners on the front edge of the seat.
• Using a slotted screwdriver, turn both lock fasteners
a ¼ turn to the unlocked position .
• Grasp under the front of the seat and lift firmly to
remove it.
Battery Connector
Battery Retainer
• Plug the battery connector into the motor
harness connector.
Note: If the battery connector will not plug into the
motor harness connector, turn it over and try again!
Do not force the battery connector into the motor
harness connector.
• Re-assemble the seat to the vehicle. Using a slotted
screwdiver, turn the lock fasteners a ¼ turn to the
locked position
.
IMPORTANT! Always remember to keep the lock
fasteners locked at all times to prevent children from
accessing the battery.
IMPORTANT! Use only a Power Wheels
®
6 volt
(4.0 Amp/Hr) rechargeable battery. Use of any other
battery will damage your vehicle.
BATTERY INSTALLATION
1
3
2
4
LOCKED UNLOCKED