Filter
Top Products
18
Motor is not running; Power is not on Turn the power dial to one of six settings.
no swinging
Batteries incorrectly installed Remove the batteries and replace in correct orientation, as
indicated inside the battery compartment.
Dead batteries Replace all four batteries with four, fresh “D”alkaline batteries.
Motor is running but Need to start swinging motion To start swinging motion, give the seat a light push.
swinging stops after a
few minutes Swing motion setting is inappropriate Adjust the power dial to a higher speed setting and give the
for child’s weight seat a light push.
Weak batteries Replace all four batteries with four, fresh “D”alkaline batteries.
No difference noticed in Swing did not have sufficient time Allow the swing time to adjust to new setting.
swinging motion after to adjust to different setting
power dial is adjusted
Weak batteries Replace all four batteries with four, fresh “D”alkaline batteries.
Swinging motion too high Normal operation To slow swinging motion, place one end of a blanket underneath
even at the lowest setting your child and let the other end drape down while swinging.
Waterglobe (lights)/mobile, Power dial is not on correct setting Position the power dial to the position.
music/sounds do not work
and swing is off Dead batteries Replace all four batteries with four, fresh “D”alkaline batteries.
Waterglobe (lights)/mobile,music/sounds Press the reset button to restart waterglobe (lights)/mobile,
turn off automatically after seven minutes music/sounds for another seven minutes.
Music/sounds do not work Music/sounds switch is Slide music/sounds switch to desired setting .
(and power dial is set to ) in OFF position
Music/sounds turn off Press the reset button to restart music/sounds for
automatically after seven minutes another seven minutes.
Waterglobe (lights) does not Mobile/waterglobe switch is in Slide mobile/waterglobe (lights) switch to desired setting .
work (and power dial is set to ) OFF position or mobile only position
Waterglobe (lights)/mobile turn off Press the reset button to restart waterglobe (lights)/mobile
automatically after seven minutes for another seven minutes.
Mobile does not work Mobile/waterglobe (lights) switch is in Slide mobile/waterglobe (lights) switch to desired setting .
(and power dial is set to ) OFF position or waterglobe only position
Mobile/waterglobe (lights) turn off Press the reset button to restart mobile/waterglobe (lights)
automatically after seven minutes for another seven minutes.
e Problems and Solutions
e
Problems and Solutions
Problem Probable Cause Solution