Filter
Top Products
3
• If you are charging the battery for the first time, insert a
25 amp fuse into the battery.
Note: The top of the fuse will not be flush with the top of the
battery when properly installed.
• Fit the charger connector and the battery connector
together.
• Plug the charger into a standard 120 volt wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
• Before first time use, charge the battery for at least
18 hours. Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use
of your vehicle. Do not charge the battery longer than
30 hours.
• Once the battery is charged, disconnect the charger
connector from the battery connector. Unplug the charger
from the wall outlet. The battery is now charged and is
ready to be installed in your vehicle. Please see "Battery
Installation" on page 15 for detailed battery installation
instructions.
2
1
Battery
Connector
Charger
Connector
25 Amp
Fuse
Charger
Battery Charging
7
IMPORTANT! The battery must be removed from your
vehicle for the initial charge in order to complete assembly.
After assembly is complete, you do not need to remove the
battery from your vehicle to recharge it.
• Using a Phillips screwdriver, loosen the screw in the
battery clamp. Remove the battery clamp from the
vehicle frame.
• Remove the Power Wheels
®
6 Volt (4.0 Amp/Hr.) battery
from the battery compartment.
• Discard any cardboard that may have been used to
protect the battery during shipping.
Battery Clamp