Filter
Top Products
• Turn the vehicle frame over.
• Fit the bubble blower connector down through the
rectangular hole in the vehicle body.
18
• Fit the bubble blower to the underside of the vehicle
frame, as shown.
• Insert six screws through the bubble blower and into the
vehicle frame. Tighten the screws with a Phillips screw-
driver. Do not over-tighten.
19
Bubble Blower
Connector
Rectangular
Hole
Bubble
Blower
Assembly
12
• Insert the tab on the exhaust pipe into the slot in the
cowling, as shown.
• Push the exhaust pipe down to “snap” it into place.
17
Tab
Slot
Exhaust
Pipe
Bottom View
Bottom View
IMPORTANT! There are three electrical connections to be
made on this product. All three electrical connections must
be made in order for your product to function properly.
Please follow these instructions carefully.
• Turn the vehicle frame upright.
• Fit the bubble blower connector to the motor harness
connector. This is the second electrical connection.
Note: If the bubble blower connector will not plug into
the motor harness connector, turn it over and try again!
Do not force the bubble blower connector into the motor
harness connector.
20
Bubble Blower Connector
Motor Harness
Connector
Cowling