Filter
Top Products
Preparing Child Restraint to Fit
Your Child
If you are going to use this child restraint with
the restraint’s internal harness system, you
MUST make these adjustments with your child
before you install the child restraint in the
vehicle.
1
Make sure LATCH belt
packaging is pulled free of
child restraint shell.
2
Loosen harness by pushing
down on the harness
release lever while pulling
out on the harness.
3
Press on harness retainer
release button and pull
apart.
4
Press red button on
buckle to release the
buckle plates. Place
harness over sides of child
restraint.
Place the child’s bottom
and back flat against the
child restraint.This will
increase comfort and allow
the harness to properly
tighten.
5
continued on next page.
16 17
4358-3832A US Prospect 2/23/06 10:18 AM Page 19