Filter
Top Products
13
Attaching Infant Car Seat To Base:
Verify that there are no objects on top of base or between base and infant car seat.
Lower car seat into base and push down on car seat to lock car seat into base (fig. b).
Test to be sure car seat is locked in base. Lift infant car seat at top of seat back
(fig. c) and at front end.
Carry handle can be moved to the vehicle use position (see “Carry Handle
Operation” section).
Adjust recline using recline indicator on the side of car seat. Line on
recline indicator MUST be in green striped zone (fig. d).
If line is not in green striped zone, adjust base (see “Base Adjustment” section), and
recheck recline of car seat. Repeat until recline indicator is in green striped zone.
If base can not be adjusted to locate the line in the green striped zone:
1. Try a different seating position.
2. Do not use this infant car seat.
NOTE: Vehicle must be parked on horizontal surface during this installation.
1
(fig. b)
4
(fig. c)
WARNING
DEATH or SERIOUS INJURY can occur
• Only use the car seat LATCH System in vehicle seating locations recommended by the vehicle
manufacturer for use with LATCH and have an anchor spacing of 280 mm (11 inches).
•LATCH connectors must be secured to the vehicle LATCH anchorages only. Connection to other vehicle
components could result in the anchor tearing free in a crash.
• Never attach more than one anchor connector to a vehicle lower anchorage unless recommended by the
vehicle owner’s manual for that vehicle.
Securing Base With LATCH System:
2
3
(fig. d)
Recline
Indicator
Green
Striped
Zone
5
14
Refer to vehicle owner’s manual to identify the seating locations with LATCH
System. Select the seating location to be used and locate the vehicle lower
anchorages at the seat bight.
ALATCH Anchorage System with 280 mm (11 inches) spacing may not be available in
your vehicle in the rear center seating position. If use of the rear center position is
preferred, use the vehicle seat belt to secure the car seat. See “Securing Base
With Vehicle Seat Belt” section.
Remove car seat from base.
Remove the LATCH lower anchor belt with lower anchor connectors from the LATCH
compartment in base (fig. a).
Lengthen lower anchor belt. While pressing down on release button on top of
belt adjuster, pull belt to extend the length of lower anchor belt (fig. b).
Position the lower anchor belt with the belt adjuster slide buttons facing away from the
car seat. If the adjuster is not in that position, turn the belt and adjuster over.
Place the lower anchor belt under both belt path tabs in the base (fig. c). Belt Lock-off will
be under LATCH belt. Check that the belt is not twisted.
Adjust vehicle seat back into most upright position.
Place base rear-facing in the vehicle seat location
selected with LATCH belt toward vehicle seat back
and centered between the vehicle lower anchors
(fig. d).
(fig. a)
(fig.d)
(fig. b)
Lower
Anchor Belt
Adjuster
Slide Button
Pull
1
3
4
5
6
7
2
(fig. c)
LATCH
Compartment
8
LATCH
Lower Anchor
Belt
Adjuster
Belt