Filter
Top Products
23
Harness Use and Adjustment
Harness Strap Adjustment:
•To tighten: Pull front adjuster strap (fig. a).
•To loosen: While pressing harness adjuster lever, pull harness
straps out.
Chest Clip Operation:
•To open: Press tabs and pull apart (fig. b).
•To close: Snap halves together. Make sure chest clip is locked
by pulling out.
Carry Handle Operation - Carry handle has three positions (fig. c):
A. Carrying position
B. Vehicle use position and rocking position
C. Reclined seat position
To change carrying handle position:
• Push in handle buttons on each side of handle (fig. d).
• Rotate handle forward or backward until it locks into the
proper use position.
IMPORTANT: Check to be sure carry handle is locked
before lifting car seat.
(fig. b)
(fig. c)
A
B
C
(fig. d)
Harness
Adjuster
Lever
(Under
Pad)
(fig. a)
Harness
Adjuster
Strap
Handle
Buttons
1
2
1
2
1
2
1
1
2
2
1
1
2
Base Adjustment:
Turn recline adjustment knob to raise base (fig. a).
Push-in red recline adjustment button at center of recline adjustment knob and turn
knob to lower base.
Infant Insert:
Canopy:
Secure snaps on side of canopy to seat pad, hook canopy over back of car seat and
pull canopy forward (fig. b).
WARNING
•To prevent ejection:
Shoulder belts MUST be through belt slots in infant insert.
- For proper harness fit, infant insert MUST be used for small infants.
• Discontinue use of infant insert when:
- Child’s shoulders are above middle belt slots in seat back of car seat.
- Shoulder belts become too short to fit infant (approximately 5 months of age).
24
(fig. a)
(fig. b)