Filter
Top Products
Using the Song Sequencer
E-82
■Event Data List
The following table shows the event types that correspond to the abbreviations that appear on the display, as well as the
parameters of each event type and setting ranges.
•“
2
display” and “
4
display” in the table headings correspond to the
2
,
4
screen positions under “Reading Event Data” (page
E-81).
•“
2
display during insert” in the table headings indicates the event type name enclosed in thick brackets (%) when step 3 of
insert event procedure under “To insert an event” (page E-87).
System Track and Track 01 to 16 Common Events
Track 01 to 16 Events
Event Type
2
display during
insert
4
display Parameter Name Setting Range
2
display Event Name
TOP (song start point) – – – (Not editable)
*1
Note [Note]
NOTE Note name C- - C0 - G9
*2
GATE Gate time 00:00 - 99:95
VEL Velocity 001 - 127
Bend Pitch Bender [Bend] VALU Pitch Bender –8192 - 0000 - +8191
Mod Modulation
*3
[Modulat] VALU Modulation 000 - 127
END (song end point) – – – (Not editable)
*1 A note event is not displayed as the event name at position
2
, but rather as the note name (C4, etc.).
*2 “C-” on the display indicates C-1 (one octave below C0).
*3 This event can be added only with the operation under “To insert an event” (page E-87). It applies vibrato.
Event Type
2
display during
insert
4
display Parameter Name Setting Range
2
display Event Name
TONE Part Tone [Tone] VALU Tone Number A:001 - L:010
Sus Part Sustain Pedal [Sustain] VALU Sustain Pedal 000 - 127
Sost Part Sostenuto Pedal [Sostenu] VALU Sostenuto Pedal 000 - 127
Soft Part Soft Pedal [Soft] VALU Soft Pedal 000 - 127
Vol Part Volume [Volume] VALU Part Volume 000 - 127
Pan Part Pan [Pan] VALU Part Pan –64 - 00- +63
CTun Part Coarse Tune [CrsTune] VALU Part Coarse Tune –24 - 00 - +24
FTun Part Fine Tune [FinTune] VALU Part Fine Tune –99 - 00 - +99
BndR Part Bend Range [BendRng] VALU Part Bend Range 00 - 24
RSnd Part Reverb Send [RevSend] VALU Part Reverb Send 000 - 127
CSnd Part Chorus Send [ChoSend] VALU Part Chorus Send 000 - 127
SclE Part Scale Enable [ScaleEn] VALU Part Scale Enable on, oFF
DspL Part DSP Line [DspLine] VALU Part DSP Line on, oFF
Exp Part Expression
*4
[Express] VALU Expression 000 - 127
*4 This event can be added only with the operation under “To insert an event” (page E-87). It changes the volume.