Filter
Top Products
Music Presets
E-53
Preset areas numbered F:001 through F:050 are for storage
of user presets. You can have up to 50 user presets stored in
memory at one time. You can recall a stored user preset after
pressing the L-8 ([F] USER RHYTHMS) button. See “To
perform using a music preset” (page E-49) for more
information.
1.
Perform steps 1 through 4 under “To perform
using a music preset” (page E-49) and select
the music preset you want to edit in order to
create your user music preset.
2.
Configure tone and other settings referring to
“Music Preset Settings” (page E-51).
3.
While holding down the R-13 (FUNCTION)
button, press the C-13 (MENU) button.
• This displays the MP (music preset) editor screen like
the one shown below.
• Pressing the R-16 (ENTER) button here will change to
a screen for editing the chord progression. See “Editing
a Chord Progression” (page E-57) for more information.
4.
Use the R-17 (t, y) button to move the 0 to
“Parameter” and then press the R-16 (ENTER)
button.
• This displays the parameter menu.
5.
You can change each of the parameters on the
parameter menu as required.
Creating a User Preset
User Preset Numbers
To create and save a user preset
(1)Use the R-17 (t, y, u, i) buttons to move 0 to
the parameter you want to change.
(2)Use the dial or the R-14 (–, +) buttons to change the
setting value.
• Pressing the R-14 (–, +) buttons at the same time
returns a parameter to its initial default setting.
• The following explains the meanings and setting
ranges of the on-screen items. The settings marked
with an asterisk (*) in the “Setting Range” column
are initial defaults.
Item name Description
Setting
Range
Synchro
(Synchro type)
Specifies the Auto
Accompaniment synchro
start standby type.
oFF, Normal
*
,
Variation,
Intro
IntroChd
(Intro chord)
Specifies the chords of the
Auto Accompaniment intro
pattern.
C
*
- B,
Cm - Bm
EndingChd
(Ending chord)
Specifies the chords of the
Auto Accompaniment
ending pattern.
C
*
- B,
Cm - Bm
AutoFill
(Auto fill in)
Specifies whether a fill in
should be inserted (on) or
not inserted (oFF) at the
end of the chord
progression.
on
*
, oFF
Timing
(Timing set)
Specifies the chord change
timing during playback for
recorded chords. For
information about
differences in playback for
each setting value, see
“Timing Setting and Chord
Progression Playback”
(page E-55).
Normal
*
, Half,
Double, 3/4,
3/2
(3)Repeat steps (1) and (2) as required.
(4)After the settings are the way you want, press the R-15
(EXIT) button.
• This returns to the MP editor screen.