Filter
Top Products
- 8 -
12. INSTALL THE BLOWER (INTERIOR BLOWER ONLY)
Assemble barrel nut (packed with blower) approximately halfway onto threaded
stud on top inside of hood.
Lift blower to top inside of hood. Slide blower back to engage blower tab with slot
in hood top and slot in blower with barrel nut.
HD0061
11. INSTALL THE HOOD
Rest the top back cavity of the hood on the wood mounting strip.
Attach transition to 10” round duct. Secure the hood to wood mounting strip with
(5) screws provided at locations shown. Drill (2) 3/16’’ size holes into the drywall
for wall anchors through the existing holes in the inside hood back in the
locations shown. Then, install the two wall anchors with the remaining #8 x 3/4”
screws and the (2) washers provided.
CAUTION
Hold the hood until it is completely secured to the wood
mounting strip.
HD0184
TOP OF HOOD (INSIDE VIEW)
M
OUNTING SCREWS LOCATION
SLOT IN TOP
OF HOOD
BARREL NUT ON
THREADED STUD
DISCHARGE
OPENING
DISCHARGE
OPENING
WALL ANCHORS LOCATION
BACK OF HOOD (INSIDE VIEW)
Use a long, flat-bladed screwdriver to tighten the barrel nut securely. Plug motor
into receptacle, on exterior side of wire box.
HD0054
BLOWER MOTOR
FLAT-BLADED
SCREWDRIVER
BARREL NUT
9. INSTALL THE TRANSITION
Attach the provided transition to top of hood. Use metal duct tape to make all
joints secure and air tight.
HD0057
CAUTION
If this decorative flue is installed in a salt water area (example: coast), rinse all surfaces once a week with
clear water (even if the hood is not used), and wipe dry completely.
10. INSTALL THE DECORATIVE FLUE (OPTIONAL)
OPTIONAL DECORATIVE FLUE AEWPD SERIES
Refer to the instructions included with the optional decorative flue.