Filter
Top Products
- 4 -
1. PREPARE THE HOOD LOCATION AND SELECT THE INSTALLATION TYPE
This exhaust hood is designed for use with gas or electric outdoor cooking appliances when operated in an outdoor covered
patio or lanai area. As with all electric appliances, this unit should be protected from the effects of weather as much as possible.
Either an interior or exterior blower or in-line blower may be used with this hood. The Best by Broan WPD29M Series must be
installed with blower models P12D, ILB11, EB12 or EB15 only. Other blowers cannot be substituted. (Blowers sold separately.)
Plan where and how the ductwork will be installed.
If installing ILB11 in-line blower, discard its rough-in plate. Refer to instructions packed with in-line blower and follow
steps 1 up to 6, 8, 9, 10, 11, 13 and up of this manual.
Install 10” round galvanized steel ductwork, elbows and roof or wall cap for the type of blower you are installing. Use metal duct
tape to seal duct joints.
The minimum hood distance above cooktop must not be less than 30’’. A maximum of 36” above cooktop is highly
recommended for best capture of cooking impurities.
Distances over 36” are at the installer and users discretion.
Run power cable to installation location.
18"
WALL CAP
30" TO 36" ABOVE
COOKING SURFACE
17 11/16" to
TOP OF WOOD
MOUNTING STRIP
HOOD
OPTIONAL DECORATIVE
FLUE or SOFFIT
9" x 18" to 10"
ROUND
TRANSITION
INCLUDED
HH0073A
ROOF CAP
10" ROUND DUCT
10" ROUND ELBOW
EXTERIOR
BLOWER
HH0074A
18"
30" TO 36" ABOVE
COOKING SURFACE
17 11/16" to
TOP OF WOOD
MOUNTING STRIP
HOOD
OPTIONAL DECORATIVE
FLUE or SOFFIT
9" x 18" to 10"
ROUND
TRANSITION
INCLUDED
10" ROUND DUCT
10" ROUND ELBOW
MODEL P12D DUAL INTERIOR
BLOWER TYPICAL DUCTWORK
MODEL EB12 OR EB15 EXTERIOR
BLOWER TYPICAL DUCTWORK
HH0075A
30" TO 36" ABOVE
COOKING SURFACE
HOOD
WALL
CAP
ROOF CAP
IN-LINE BLOWER
10" ROUND DUCT
MODEL ILB11 IN-LINE BLOWER
TYPICAL DUCTWORK
WARNING
This unit is not designed for use with a charcoal grill.
!
WARNING
The power cable must be a GFCI protected branch circuit.
!