Filter
Top Products
- 6 -
6. INSTALL WOOD MOUNTING STRIP
Measure and mark a level line on wall above cooktop location for the wood
mounting strip (see illustration on page 4).
Center the wood mounting strip over location. See illustration shown at side.
Use #10, 2’’ flat head screws to secure the mounting strip to the drywall.
Make sure to hit the wall studs.
CAUTION
Due to the weight of this hood, ensure that the wood strip is
attached to every available stud, not into the drywall alone.
HD0192A
7. SELECT BLOWER OPTION (EXTERIOR OR INTERIOR)
INTERIOR BLOWER: Follow all subsequent steps of this manual.
EXTERIOR BLOWER: Discard the exterior blower rough-in plate. Refer to instructions packed with exterior blower and follow
steps 8 to 11, 13 and up of the present manual.
5. REMOVE THE TRANSITION
Using a Phillips no. 2 screwdriver, remove and discard both screws and washers
retaining the transition to the hood. Remove the transition and the wood mounting
strip (on back of hood) and set aside.
R
R
ETAINING
ETAINING
SCREWS
SCREWS
AND
AND
WASHERS
WASHERS
LOCATION
LOCATION
HD0191
1. Drywall
2. Wood mounting strip
3. Flat head screw
4. Wall anchor location
5. Back of hood outline
6. Wall studs