Filter
Top Products
12 13
Installation: ISOFIT
TM
Connectors
Installation: ISOFIT
TM
Connectors
IMPORTANT: Before installing the
Expressway in your vehicle, make
sure that the shoulder slots are at
the correct level for your child.
See "Checking Harness Height"
on page 6).
1 Place the child seat, with har-
ness tightened, facing away from
you on the vehicle seat. (See
Figure A)
2 Loosely attach the furthest
ISOFIT connector to the LATCH
bar. (See Figure B) If unable to
make attachment, squeeze
release trigger, then try again.
3 Loosely connect tether strap to
tether anchor.
4 Rotate child seat into a forward
facing position.
5 Connect the second ISOFIT
connector to the LATCH bar.
IMPORTANT: The ISOFIT straps
must be routed around the shell.
If the connections are made with
a direct route to the LATCH bars,
re-route the straps as shown in
Figure E, then continue.
6 With one hand, push the child
seat down into the vehicle seat
cushion, while pulling the each
ISOFIT connector strap tight. (See
Figure D)
7 Pull tether strap to tighten the
tether connection. (See Versa-
Tether on pages 18-19)
8 Verify that all connections are
tight and the child seat is secure.
To remove your Expressway
1 Loosen and unhook the tether
strap from the vehicle.
2 Loosen the ISOFIT straps by
pushing the adjuster tab on each
connector away from the child
seat.
3 Squeeze the red trigger to
release each ISOFIT connector.
LATCH Bars
A
C
B
D
Open
Closed
E