Filter
Top Products
B
3 From rear of seat, remove c-
clips from HUGS straps. (See
Figure B)
4 Unhook the shoulder straps
from the yoke. (See Figure C)
5 Pull all straps through the shell
and cover, to the front of the
seat.
6 Thread the harness straps
through the appropriate harness
height slots. (See Figure D)
7 Reattach harness straps to the
yoke. (See Figure C)
8 Pull harness adjuster strap to
tighten the harness.
9 Thread HUGS straps over the
harness straps and through the
same slot as the corresponding
harness strap.
10 Reattach a c-clip to the loop
at the end of the HUGS straps.
(See Figure B)
11 Pull HUGS down as far as it
will go and verify that all straps
are threaded at the same height
and are not twisted.
Checking Harness Height
6 7
Adjusting Harness Height
The shoulder harness MUST be threaded through the slots in the
cover and shell nearest the top of your child’s shoulders. If in any
doubt always use the slot above the shoulder rather than below it.
Once the top slots become necessary, your child may continue to
use the seat until the center of the ears become level with the top
of the seat shell or weight exceeds 40 lbs.
1 Remove the soft pads by
releasing the hook and loop fas-
tener connection.
2 Loosen the harness by pushing
the harness release button while
pulling the shoulder straps for-
ward as far as possible. Use the
pull rings to aid in loosening the
harness. (See Figure A)
Adjusting Harness Height
A
C
D