Filter
Top Products
16 17
Installation: Lap Belt Only
Installation: Lap Belt Only
C
IMPORTANT: Before installing the
Expressway in your vehicle, make
sure that the shoulder slots are at
the correct level for your child.
See "Checking Harness Height"
on page 6).
1 Place the Expressway facing
forward on the vehicle seat and
pull the harness tight.
2 Pass the seat belt through both
side slots and fasten buckle. (See
Figure B)
3 Before continuing, make sure
that the lap belt passes through
BOTH lower lap belt positioning
guides. (See Figure B)
This is a typical lap seat belt
configuration.
A
B
4 With one hand, push the child
seat down into the vehicle seat
cushion, while tightening the seat
belt with the other. (See Figure C)
5 Verify that the seat belt is tight
and the child seat is secure.
See "Checking Buckle Position"
on Page 20.
To remove your Expressway,
unfasten the seat belt and reverse
the above directions.
IMPORTANT: When the ISOFIT
Connectors are not in use, they
must be securely connected to
the tie wraps located under the
cover on each side of the child
seat. (See Figure D)
D