Filter
Top Products
TO UNFOLD STROLLER
TO UNFOLD STROLLER
Do Not allow children near stroller while unfolding.
1. Release the folding latch, which is located on the right side. Fig. 26.
2. Lift up on the stroller handle with both hands until the stroller frame is
erect and locked in the open position. The stroller has spring-loaded
latches on both sides of the frame. Test that both latches are fully engaged
prior to placing your child in the stroller.
STOP
IF YOU EXPERIENCE ANY DIFFICULTY IN USING THIS PRODUCT,
PLEASE CONTACT OUR CUSTOMER SERVICE DEPARTMENT AT
(800) 328-7363 BETWEEN THE HOURS OF 8:00AM AND 4:30PM PACIFIC
STANDARD TIME FOR ASSISTANCE.
TO ATTACH AN INFANT CAR SEAT
1. Recline the front seat back. Remove the child tray.
2.
Slide snap n go attachment bar into the female slots located on the
frame tube. Make sure the snap n go attachment bar locks in place
before attaching the car seat. Fig. 27.
3.
Place car seat onto front bar. Fig. 28. NOTE: Most brands of
infant car seats will lock onto the front bar, and some brands may
simply rest on the front bar, FOR SAFE OPERATION, IT IS
VERY IMPORTANT THAT THE CAR SEAT STRAP IS
ALWAYS TIGHTLY FASTENED AROUND THE CAR SEAT.
4. Strap the safety belt over the car seat and through the seat belt slots
on your car seat, connect the buckles together. Tighten the strap so
thecarseattssnugandcan'tmove.Fig. 28. Check that the car
seat is secure before using the stroller.
Fig. 27.
Fig. 28.
WARNING: Avoid serious injury from
falling, Do Not use the Snap N Go bar if it is not
securely locked onto both sides of the stroller.
8
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.