Filter
Top Products
ASSEMBLY
1. Remove stroller from box. The front wheels, rear wheels, child tray, and
canopies need to be installed prior to use.
2. To attach the front wheels, unfold stroller as described in the section
following. Fig. 1. Lean the stroller backwards so that it rests on the
handle and rear frame tubes and the front wheel tubes are pointing
upward. Position the front wheel assembly at the front tube such that
the large hole in the swivel assembly will slide onto the front tube. Push
each front wheel assembly onto the front tube being careful that wheel
assembly locks onto the front leg. Pull on the wheel assembly to ensure
that it is securely attached to the stroller. Fig. 2.
3. Lean the stroller forward to rest on the front wheels. To attach the rear
wheels, position the rear axle and wheel assembly such that the brake
levers are facing to the rear of the stroller. Press the rear wheel assembly
onto the rear frame tubes being careful that the push buttons on the
forward side of each rear tube engage the hole on the forward side of
each rear wheel housing. Pull on the rear wheel assembly to ensure that
it is securely attached to the stroller. Fig. 3.
4. Ensure that the wheels are rmly locked into place. Do Not use the
stroller if the wheels are not locked into place, but rather contact our
customer service department immediately at (800) 328-7363, between
the hours of 8:00am and 4:30pm PST, for assistance.
5. Snap footrest onto front legs of stroller just below the seat. Push
downward on the footrest until it locks onto the rivets protruding from
both sides of each leg and snaps onto the U-shaped frame cross member.
Fig. 4.
PARTS
ASSEMBLING
Child Tray
Foot Rest
Front Wheels
Stroller
Snap N Go
Attachment Bar
Rear Wheels
Parent Tray
Front/Rear Canopies
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW
THESE INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
Snap On
Push
Down
Fig. 1.
Fig. 2.
Fig. 3.
Fig. 4.
3
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
Jump Seat Pad
(optional)