Baby Trend 11.07 Stroller User Manual


 
1. The rear platform and jump seat are designed to accommodate a child
who is at least 2 1/2 years old, has good balance and coordination, and is
not over 40 inches tall. Position the child on the platform on the back of
the stroller. Be sure child is facing forward and hands are holding frame.
Secure the safety belt behind child and engage buckle. Fig. 12.
2. Be sure that the child’s feet are fully on the platform at all times.
PLEASENOTE:WhenusingtherearSEATyoumustputtheSTAND
FEATURE SAFETY BELT in the storage location located on the rear of
the seat. Please See Fig. 12A
WARNING: To avoid a possible
choking hazzard when using the rear seat, put
the STAND FEATURE SAFETY BELT in the
storage location on the rear of the seat.
TO SECURE REAR STANDING CHILD
Fig. 11.
Fig. 12.
Shoulder Strap
Squeeze
Crotch Strap
Waist
Strap
Adjust for a
snug fit
Fig. 10.
STEP ONE: REMOVING THE REAR SEAT
1.Removetherearcanopybyslidingthesquarettingsupwarduntilthey
disconnect from the frame.
2. Remove the rear seat from the frame by un-buttoning the upper and lower
seat back fabric from the frame (Fig. 13 & 14) and un-snaping both front
connection points. Fig. 15
3.Detachthe(2)shoulderstrapsfromtheframebyfoldingandslidingthe
strapthroughthe“D-ring”locatedontheendofeachstrap.Fig.16.
4.Detachthecentercrotchstrapfromtheframebyfoldingandslidingthe
strapthroughthe“D-ring”locatedontheendofthestrap.Fig.17.
TO USE JUMP SEAT
Fig. 12A. Fig. 12B.
5
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
Upper
Lower
Snap point
Fig. 13
Fig. 14