Filter
Top Products
1 | page
© Adam Equipment Company 2010
CONTENTS
1.
INTRODUCTION......................................................................................3
2.
SPECIFICATIONS ...................................................................................4
3.
INSTALLATION .......................................................................................9
3.1. UNPACKING ........................................................................................................ 9
3.2. LOCATING ........................................................................................................... 9
3.3 SETTING UP THE SCALES............................................................................... 10
4.
KEYPAD ................................................................................................11
5.
DISPLAY................................................................................................13
5.1. SYMBOLS AND INDICATORS .......................................................................... 13
6.
CALIBRATION COUNTER FOR APPROVED SCALES.......................14
7.
BATTERY ..............................................................................................16
8.
BACKLIGHT ..........................................................................................16
9.
AUTO POWER OFF...............................................................................16
10.
OPERATION.......................................................................................17
10.1. ZEROING ........................................................................................................ 17
10.2. TARING........................................................................................................... 17
10.2.1 MANUAL TARE........................................................................................... 17
10.2.2 PRESET TARE (NOT AVAILABLE ON APPROVED SCALES)................. 18
10.3. WEIGHING...................................................................................................... 19
10.4. PARTS COUNTING ........................................................................................ 19
10.5. CHECK-WEIGHING........................................................................................ 22
10.5.1 SETTING UP WHILE WEIGHING ............................................................... 23
10.5.2 SETTING UP WHILE PARTS COUNTING OR % WEIGHING.................... 24
10.6. LIMITS STORING AND RECALLING............................................................. 24
10.7. PERCENT WEIGHING.................................................................................... 26
10.8. ANIMAL (DYNAMIC) WEIGHING................................................................... 29
10.8.1 ANIMAL WEIGHING PROCEDURE............................................................ 30
10.9. ACCUMULATED TOTAL................................................................................ 31
10.9.1 MANUAL ACCUMULATION ....................................................................... 31
10.9.2 AUTOMATIC ACCUMULATION ................................................................. 33
11.
RS-232 SPECIFICATION....................................................................34
11.1. INPUT COMMANDS FORMAT....................................................................... 39
12.
CALIBRATION....................................................................................40
13.
PARAMETER SETTINGS...................................................................41
13.1. CHECK WEIGHING PARAMETERS .............................................................. 41
13.2. RS-232 PARAMETERS .................................................................................. 44
13.3. SCALE PARAMETERS .................................................................................. 46
13.4. PERCENT WEIGHING AND ANIMAL WEIGHING......................................... 48
14.
ERROR MESSAGES ..........................................................................49
15.
SERVICE PARAMETERS...................................................................51
15.1. ACCESS TO PARAMETERS ......................................................................... 51
15.2. USING “1000” TO ENTER THE SERVICE PARAMETERS........................... 52
16.
REPLACEMENT PARTS AND ACCESSORIES.................................57
17.
SERVICE INFORMATION ..................................................................58
18.
WARRANTY INFORMATION .............................................................59
19.
APPENDIX..........................................................................................60