Filter
Top Products
Pipettor Programming
18
Open Dilution Programming
1. Press repeatedly until the
display reads:
2. Press to enter selection.
The display shows the default setting
for the diluent aspiration volume.
3. Press or to select a
new diluent volume (0.10 - 5.00mL).
(In this case 4.50mL)
4. Press to enter selection.
The display shows a default setting
for the sample aspiration volume.
5. Press or to select a
new sample volume (In this case
0.50mL)
6. Press to enter selection.
Pipettor Programming
17
5mL Pipetting
1. Press repeatedly until the
display reads:
2. Press to enter selection.
3. Attach a pipette tip to the tip cone.
The pipettor is now ready to aspirate
5.00mL.
4. Place the tip in the sample and press
the Start Button. The unit will aspirate
5.00mL.
The next display indicates that the unit
is ready to dispense the total volume
(5mL) with blowout.
5. Position the pipette tip to dispense and
press the Start Button. The unit will
dispense the full amount from the tip.
The display now indicates that the unit
is ready to repeat the 5mL pipetting,
beginning with the 5.00mL aspiration.
Page 9 of 15 - June 2001