Filter
Top Products
Software Installation Procedure 23
Example Host IP address [192.9.200.14]: 192.9.200.96
Install file pathname[/usr/cb2500/lp2500c]:
User name: scottco
Password:
Programming flash memory block 1 of 15...
Programming flash memory block 2 of 15...
Programming flash memory block 3 of 15...
.
.
Programming flash memory block 15 of 15...
Installation complete.
6
Proceed to “Rebooting the System” next.
Rebooting the System
To reboot your system, follow these steps:
1
From the top level of the Administration Console, enter:
system reboot
2
When the reboot is complete, log in to the system and proceed to
“Reloading the Compressed Image” next.
Reloading the Compressed Image
You must load the compresed image file again. Follow these steps:
1
From the top level of the Administration Console, enter:
system softwareUpdate
The system prompts you for several items of information.
Press Return at any prompt to accept the default value that is shown in
brackets.
2
At the
Host IP address
prompt, enter the IP address of the host
device from which you are retrieving the compressed image.
3
At the
Install file pathname
prompt, enter the complete path
and filename.
Paths and filenames are case-sensitive. Be sure to type them exactly as
shown on the hard disk of the host device.
For an MS-DOS host, you must precede the full path with a forward
slash (/). Example:
/c:\3com\cb2500\lp2500c
4
At the
User name
prompt, enter your user name.