8-7
5. Remove the oil filter cover by removing
the bolts and then remove the oil filter el-
ement.
6. Clean the oil strainer and oil filter element
with solvent.
1. Oil filter cover 2. Bolt (× 3)
3. Oil filter element 4. O-ring
7. Check the O-ring for damage and re-
place it if necessary.
8. Install the oil filter element and O-ring.
9. Install the oil filter cover by installing the
bolts.
10. Install the oil strainer, compression
spring, O-ring and drain bolt. Tighten the
drain bolt and oil filter cover bolts to the
specified torques.
CAUTION:
_
Before installing the drain bolt, be sure to
install the O-ring, compression spring and
oil strainer.
_
11. Add the specified amount of the recom-
mended engine oil, and then install the
engine oil filler cap.
Tightening torques:
Drain bolt:
32 Nm (3.2 m·kgf, 23 ft·lbf)
Filter cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
U5NF12.book Page 7 Wednesday, May 8, 2002 11:11 AM
