8-10
8. Clean the oil strainer and oil filter element
with solvent.
9. Check the O-ring for damage and re-
place it if necessary.
NOTE:
_
Make sure the O-ring is seated properly.
_
10. Install the oil filter element.
11. Install the oil filter element cover by in-
stalling the bolts, and then tightening
them to the specified torque.
12. Install the oil strainer, compression
spring, O-ring and engine oil drain bolt,
and then tighten the engine oil drain bolt
to the specified torque.
CAUTION:
_
Before installing the engine oil drain bolt,
be sure to install the O-ring, compression
spring and oil strainer.
_
13. Add the specified amount of the recom-
mended engine oil, then install and tight-
en the engine oil filler cap.
Tightening torque:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kgf, 31 ft·lbf)
Recommended engine oil:
See page 10-2.
Oil quantity:
Without oil filter element removal:
1.50 L (1.32 Imp qt, 1.59 US qt)
With oil filter element removal:
1.60 L (1.41 Imp qt, 1.69 US qt)
EE.book Page 10 Friday, May 27, 2005 2:09 PM
