11
Connecting an Earphone
For private listening, you can connect an earphone with a 1/8 inch (3.5 mm) plug to the
EXT. SP. jack on the back of the scanner.
Be very careful as damage to your hearing can
result if the VOLUME control is not set to the lowest level first
. See below for “Listening
Safely” instructions. (Your local electronics store should carry a wide selection of earphones.)
Once the earphone is connected, it will automatically disconnects the internal speaker.
Listening Safely
To protect your hearing, follow these guidelines when you use an earphone or headphones.
• Do not use the earphone to listen to the WX alert siren test. The volume is not
adjustable and damage to your hearing could occur.
• Do not listen at extremely high volume levels. Extended high volume listening can lead to
permanent hearing loss.
• Set the VOLUME to the lowest setting before you begin listening. After you begin listening,
adjust the VOLUME to a comfortable level.
• Once you set the VOLUME, do not increase it. Over time, your ears adapt to the volume
level, so a volume level that does not cause discomfort might still damage your hearing.
Connecting the Clone Cable
You can transfer the programmed data to and from another BC780XLT scanner using an
RS232C Cable (9 pin to 9 pin) (not supplied). Connect the cable between each scanner’s
REMOTE jacks. See “Clone Mode” on page 66. You can also upload or download the
programmed data to or from a PC using an optional PC interface kit available through your
local electronics store.
Connecting the Tape Recorder
You can use a standard tape recorder or a VOX (Voice Operated Control) recorder.
To connect the recorder to the scanner, connect a cable with a 1/8 inch (3.5 mm) plug from
the tape recorder’s remote jack to the TAPE OUT jack on the back of the scanner. (Your
local electronics store should carry a wide selection of cables and tape recorders.) Refer to
the “Record” section under “Additional Features” in the manual.
Remember!
• You must mark a channel, ID, talkgroup, or bank for Recording in order for this
feature to work. The
LINE
icon appears on all channels that have been properly marked.
• This feature does not work if your scanner is set with MUTE ON.
• The
VOLUME
control affects the Audio output. Do not set the volume on
minimum. Make a trial taping to be certain the volume levels are set correctly.
Remote Programming Software
Software for remote programming and controlling the scanner is available for purchase by
calling (800)722-6701 or through the website www.bc780xlt.com
BC780XLT1.qxd 10/11/2000 10:39 AM Page 11
