A SERVICE OF

logo

Replacement Procedures
4.11 Touch pad
Removing the touch pad
The following describes the procedure of removing the touch pad.
1. Peel off the glass tape and disconnect the touch pad flat cable, finger print cable
from the connector on the touch pad.
2. Remove the following screws securing the touch pad plate.
M2.0×2.0B SUPER THIN HEAD screw x4
3. Remove the touch pad board and touch pad plate.
4. Peel off and remove the touch pad from the cover assembly.
Figure 4-21 Remove the touch pad
Satellite U400/Satellite Pro U400/PORTEGE M800 Maintenance Manual 36