122
Remote Commander
(DCR-SR62/SR82/SR200/SR300)
ADATA CODE button (60)
Displays the date and time or camera setting
data of the recorded images when you press this
during playback.
BPHOTO button (20, 24)
The on-screen image when you press this
button will be recorded as a still image.
CSCAN/SLOW buttons (21, 32)
D. > (Previous/Next) buttons (22,
32)
EPLAY button (21, 32)
FSTOP button (21, 32)
GDISPLAY button (14)
HTransmitter
ISTART/STOP button (20, 24)
JPower zoom buttons (25, 33)
KPAUSE buttons (21, 32)
LVISUAL INDEX button (21, 31)
Displays the VISUAL INDEX screen when you
press this during playback.
M b / B / v / V / ENTER buttons
When you press any button on the VISUAL
INDEX screen or Playlist, the orange frame
appears on the LCD screen. Select a desired
button or an item with b / B / v / V, then press
ENTER to enter.
b Notes
• Remove the insulation sheet before using the
Remote Commander.
• Point the Remote Commander towards the remote
sensor to operate your camcorder (p. 120).
• When no commands have been sent from the
Remote Commander in a certain period, the
orange frame disappears. When you press any of
b / B / v / V, or ENTER again, the frame appears
at the position where it was displayed last.
• You cannot select some buttons on the LCD
screen using b / B / v / V.
To change the battery of the Remote
Commander
1 While pressing on the tab, inset your
fingernail into the slit to pull out the battery
case.
2 Place a new battery with the + side facing
up.
3 Insert the battery case back into the Remote
Commander until it clicks.
• When the lithium battery becomes weak, the
operating distance of the Remote Commander
may shorten, or the Remote Commander may
not function properly. In this case, replace the
battery with a Sony CR2025 lithium battery.
Use of another battery may present a risk of fire
or explosion.
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in
fire.
Insulation sheet
Tab
