A SERVICE OF

logo

General Installation
Installation Manual 113
Inserting the Connector
1. Insert the two 50-pin connectors to the jacks as shown below.
The connector "TO SYSTEM" should be connected to the cable which is connected to the
KX-TD816 / KX-TD1232.
Also, the connector "TO EXTN" should be connected to the cable which is connected to the
extensions.
2. Insert the cables through the binders.
3. If two units are connected with the DC IN / OUT, insert the 4-pin connectors to the jacks
as shown on the next page.
25
50
1
26
Connector type
50-pin (Amphenol 57JE
series or the equivalent)
Connector
(
TO SYSTEM
)
Connector
(
TO EXTN
)
To ExtensionsTo System (TD816 / TD1232)
Binders