Chapter 4 263
Command Definition F-K
FTN
If you create the USL prior to compilation, you must specify a file code of USL or 1024. If
you omit the uslfile parameter, the object code is saved in the temporary file domain as
$OLDPASS. To keep it as a permanent file, you must save $OLDPASS under another name.
You cannot backreference the formal file designators used in this command (FTNTEXT,
FTNUSL, and FTNLIST) as actual file designators in the command parameter list. For
further information, refer to the "Implicit FILE Commands for Subsystems" discussion of
the FILE command.
Use
This command may be issued from a session, job, or program. It may not be used in
BREAK. Pressing
Break suspends the execution of this command. Entering the RESUME
command continues the execution.
Examples
The following example compiles an HP FORTRAN 77/V program entered from your
standard input device and stores the object program in the USL file $OLDPASS. The listing
is then sent to your standard list device.
FTN
The next example compiles an HP FORTRAN 77 program contained in the disk file
FORTSRC, and stores the object program in the USL file FORTOBJ. The program listing is
stored in the disk file LISTFILE:
BUILD FORTOBJ;CODE=USL
FTN FORTSRC,FORTOBJ,LISTFILE
Related Information
Commands FTNGO, FTNPREP
Manuals HP FORTRAN 77/iX Reference
MPE Segmenter Reference Manual
