GNC 420(A) Pilot’s Guide and Reference
7-12
SECTION 7
WPT PAGES
7) Turn the small right knob to display a window
of available runways (Figure 7-25). Continue
turning the small right knob to select the
desired runway. ‘ALL’ may appear in the
runway field, indicating the arrival procedure
applies to all runways. For airports with
parallel runways, ‘B’ may appear at the end of
the runway designation to indicate the arrival
procedure applies to both runways.
Figure 7-25 Runway Window
8) Press the ENT Key. To remove the flashing
cursor, press the small right knob.
Airport Arrival Page Options
The following option is available for the Airport Arrival
Page, by pressing the MENU Key:
‘Load into Active FPL?’ allows the pilot to load the
selected arrival into the active ight plan. This is identical
to loading an arrival procedure from the Procedures Page,
as described in Section 6.1.
Loading an arrival procedure from the
Airport Arrival Page:
1) Select the desired arrival, transition, and
runway using the steps above.
2) Press the MENU Key to display the Airport
Arrival Page Menu.
3) Press the ENT Key to select the ‘Load into
Active FPL?’ option (Figure 7-26).
Figure 7-26 Airport Arrival Page Menu
4) The Active Flight Plan Page appears. Press the
FPL Key to return to the Airport Arrival Page.
190-00140-20 Rev. K
