Chapter 3 Powering On the System 49
Note – After setting the configuration parameters, you must enter the set
/SP/network commitpending=true command for the new values to take affect.
5. Commit the changes to the service processor network parameters.
Note – You can run the show /SP/network command again (after performing the
set /SP/network commitpending=true command) to verify that the
parameters have been updated.
Properties:
commitpending = (Cannot show property)
dhcp_server_ip = xxx.xxx.xxx.xxx
ipaddress = xxx.xxx.xxx.xxx
ipdiscovery = dhcp
ipgateway = xxx.xxx.xxx.xxx
ipnetmask = 255.255.252.0
macaddress = 00:14:4F:3F:8C:AF
pendingipaddress = xxx.xxx.xxx.xxx
pendingipdiscovery = static
pendingipgateway = xxx.xxx.xxx.xxx
pendingipnetmask = 255.255.255.0
state = enabled
Commands:
cd
set
show
->
-> set /SP/network commitpending=true
Set 'commitpending' to 'true'
CODE EXAMPLE 3-1 show /SP/network Command Output
