the power port. The power port is the first port on the left side.
The connector is keyed so that it will plug in only one way and
it should slide in easily.
Next, connect the other end of the cable to the port on the
backside of the disk drive. It also fits in one direction and
should easily snap into place.
On the front of the disk drive is the 3.5-inch slot opening for
the diskette. Insert the diskette gently into the disk drive and
push it in until you hear a slight click. The small rectangular
button on the right side of the drive is the diskette eject button.
Note: Diskettes can be inserted only one way. If you do
not feel or hear a slight click, then turn the floppy
disk 180 degrees and reinsert it into the drive.
With the front of the disk drive facing you, you should be able
to feel the On/Off switch on the left of the backside, just right
of the cable port. Press on the right edge of the switch to turn
the disk drive on.
Note: As a battery-saving feature, the disk drive will not
operate unless the DDA cable is plugged into the
disk drive.
On the right of the backside is the battery-charger jack. The
disk drive fully recharges in about 8 hours. Built into the disk
drive is a battery low detection circuit that monitors when the
voltage goes below a certain threshold. When the battery
charge is low the disk drive sounds a long series of beeps.
At this time, it is recommended that you plug the battery
charger into the unit. You can use the disk drive safely while it
is charging.
Part # 440057-001 Rev. A 3
