5
2. Preparing to Print
This section gives instructions for connecting the machine and computer, config-
uring the machine, and installing software.
❖
❖❖
❖ When operating the machine with a USB connection, parallel connection, or IEEE
1394 (SCSI print) connection
• Connect the machine and computer using a USB cable, a parallel cable, or
an IEEE 1394 (SCSI print) cable.
Reference
For more information, see p.6 “Connecting the Machine”.
• Install a printer driver from the CD-ROM.
Reference
For more information, see p.13 “Installing the Software”.
❖
❖❖
❖ When operating the machine under a network environment
• Configure the network using the machine's control panel.
Reference
For more information, see "Network Configuration", Network Guide.
• Install a printer driver and other utilities from the CD-ROM.
Reference
For more information, see p.13 “Installing the Software”.
Note
❒ "Network environment" describes a situation where the machine is connected
to a computer via Ethernet, wireless LAN, or IEEE 1394 (IP over 1394).
StellaC2-GB-Pref1-F3_FM_ZF.book Page 5 Friday, November 21, 2003 8:42 PM
