135
E
Additional
Information
Troubleshooting
Cause and/or what to do about it
• The camcorder is not set to the
appropriate mode ( 19, 28).
• The cassette is not loaded or is set for
erasure prevention ( 17-18).
• The cassette has reached the end.
• The power source is not properly
connected, or the battery pack is
exhausted or not properly attached
( 12-16, 129).
• The function cannot be used in that
recording program ( 56).
• The camcorder was in record pause
mode for more than about 5 minutes
( 19, 103).
• The battery pack is exhausted
( 13-16, 129).
• The battery pack’s power is exhausted.
Recharge or change to a new battery
pack ( 13-16).
• The cassette is not loaded or is set for
erasure prevention ( 17-18).
• The cassette has reached the end.
• The camcorder is malfunctioning.
Remove and then replace power
source.
• The camcorder is not set to the
appropriate mode ( 19, 28).
• You are attempting to play back or
record copyright protected material
( 87).
• The video heads are badly
contaminated ( 133).
Refer to this checklist first if you have any problems with your camcorder.
Possible explanations are given for each problem on the list — turn to the page
numbers in parentheses for more information.
Make sure that the camcorder is properly connected if you are using it with a TV
or VCR. Consult your dealer or service outlet if problems persist.
Recording/Playback
Problem
? Nothing happens when I press the
buttons.
? The camcorder turned itself off.
? The cassette compartment stopped
mid-operation while
loading/unloading a cassette.
? The start/stop button doesn’t work.
?
The mark flashes red in the
display during charging the flash.
? There’s no picture in the display.
? There’s a blank blue screen in the
display.
6_OPTURA100 MC_E(126-158) 7/24/01 13:42 Page 135
