rubber cap is attached to the machine's FAU Connector. When connecting the cable, remove th
rubber cap and plug in the cable.
2.
Place the Film Guide on the Platen.
lign the tabs on the Film Guide with the FAU marks on the Platen.
3.
Load the film into the Film Guide.
Place the film with its front side (the side on which the image appears correctly) facing up, aligning
the spaces between frames with the guidelines on the Film Guide.
4.
Remove the Film Adapter Unit cover and gently place the unit over the frame you
want to scan.
lign the tab on the Film Adapter Unit with the mark on the Film Guide.
5.
Gently close the Document Cover.
Important
The Document Cover does not close tightly. Do not force to close the cover or place your hand on it.
Be careful not to lose the removed cover. Keep the inside of the cover clean.
Be sure to attach the protective cover to the Film Adapter Unit when not scanning film. Dust and
scratches on the light source may affect the image quality or damage the film.
Page 22 of 308 pagesPlacing Documents
