Document No. 10-300090, Issue 1 24-9
RADIUS
set radius authentication switch-service-type-
required
Command Mode Global Configuration.
Description If you enable switch-service-type-required, the switch recognizes only
Access Accept messages that have the correct group name included. This
setting prevents the switch from incorrectly allowing access to users that
may have a user account on the RADIUS server but should not be allowed
access to the switch. If this setting is disabled, any user account that is not
assigned to a group could log in to the switch.
Syntax
Sample Output
The following command enables the switch-service-type-required setting:
(configure)# set radius authentication switch-service-type-
required enabled
Systems P550R, P580, P880, and P882.
To Enable: set radius authentication switch-service-type-required
enabled
To Disable: set radius authentication switch-service-type-required
disabled
