KL9108 / KL9116 User Manual
16
Installation
Installing your new KL9108 / KL9116 involves the following seven steps.
Refer to the diagram on the following page (the numbers in the diagram
correspond to the numbers of the installation steps) and do the following:
1. (Optional) Connect the external console’s monitor, keyboard, and mouse
to the console ports on the rear panel of the KVM switch.
2. Using a KVM cable set (as described in the Cables section on page 7),
plug the custom SPHD connector into any available KVM port on the
switch.
3. At the other end of the cable, plug the keyboard, mouse and video cables
into their respective ports on the computer.
Repeat Steps 2 and 3 for any additional computers you are installing.
4. Plug the LAN, WAN or Internet cable into the LAN port on the rear panel
of the KL9108 / KL9116.
5. Connect the power cord to the switch and to an AC power source
appropriate for the KL9108 / KL9116.
6. Power on the switch.
7. After the switch is powered on, power on the computers.
Note: Although the KL9116 is pictured in the diagram, the installation process
is the same for the KL9108.
