Filter
Top Products
4
RW 220 Vehicle Cradle Installation Guide
Special Notices
The following notices emphasize certain information in the guide. Each serves a
special purpose and is displayed in the format shown:
Note: Note is used to emphasize any significant information.
Caution: Indicates information that, if not followed, can result in damage
to software, hardware, or data.
Caution-This symbol indicates a potentially hazardous situation which, if
not avoided, can result in personal injury.
Caution-This warning symbol indicates a potentially hazardous situation
which, if not avoided, may be a shock hazard.
Caution: This warning symbol also indicates an imminently hazardous situ-
ation which, if not avoided will result in death or serious injury. Before you
work on any equipment, be aware of the hazards involved with electrical
circuitry and be familiar with standard practices for preventing accidents
Vehicle Installation Safety
Caution: Only trained and qualified personnel should be allowed to install,
replace, or service this equipment.
Caution: DO NOT OPERATE THE PRINTER WHILE DRIVING, as this may result
in property damage or personal injury. Zebra Technologies Corp. does not
promote the use of these products except when parked or stationary, and
is not responsible for any loss resulting from the use or misuse of our prod-
ucts. Most importantly, we do not want to see harm come to our customers
or anyone else.
Caution: Do not install the Vehicle Cradle where the printer will be exposed
to precipitation or excessive condensation.
Caution: Do not install the Vehicle Cradle on or near an airbag cover plate
or within an airbag zone. Also, do not install the Vehicle Cradle in a loca-
tion that will affect vehicle safety or drivability.
Caution: If you are using a Mobile Charger in conjunction with the Vehicle
Cradle, the means of routing and securing the Power Input cable to the
vehicle power source is extremely important. Hazards associated with im-
proper wiring can be severe. To avoid unintentional contact between the
wire and any sharp edges, provide the cable with proper bushings and
clamping where it passes through openings. If the wire is subjected to
sharp surfaces and excess engine vibration, the wiring harness insulation
can wear away, causing a short between the bare wire and the chassis.
If you are using a Mobile Charger in conjunction with the Vehicle Cradle
it is very important to ensure you make the correct cable to power source
connections, because electrical energy from a vehicle’s power system can
harm equipment and people.
Caution: If you are using a Mobile Charger in conjunction with the Vehicle
Cradle, always refer to the installation guide provided with the charger for
complete safety precautions and installation procedures.