Filter
Top Products
11
RW 220 Vehicle Cradle Installation Guide
continued on next page
• Turn the vehicle’s power source on, and verify that the
power indicator light and the charger light on the charger
module are lit.
4. Turn the printer on and print a configuration label to verify
that the printer is functioning properly.
Refer to the RW Series User’s Guide for instructions on printing a configura-
tion label.
5. If you will be communicating to a data terminal with a data
I/O cable, turn the printer off, plug in the data I/O cable and
turn the printer back on.
Removing the Printer
Please refer to Figure 4. Remove the Printer by doing the follow-
ing:
• Turn the Printer off.
• If the Printer is directly connected to a communications ca-
ble, unplug and remove the cable from the Printer.
• If you are using a Zebra Mobile Charger, unplug the charger
Figure 4: Removing the Printer from the Vehicle Cradle
Lift the printer free
of the retaining
pins.
Lift the Latch
Button to
release the
Printer.
Rotate the Printer out
of the Cradle.
1
2
3