Filter
Top Products
14 ► EP30200 / EP30250 User Manual
In order to perform this trouble shooting you will need: voltmeter, 8 mm and 10 mm spanners, hexagon spanner
3 mm, 4mm and 5 mm, control instrument to check lift height for S15 pistol.
Working material Are the bonds in good condition - no breaks, clean ?
Are the pins of the correct type ?
Grinding wheeel Is the grinding wheel the approved type ?
The Tyrolit is a silicon free wheel.
You can use a steel carbide wheel.
No other wheels are allowed.
Brazing gun
S 15 Check cables, plugs.
Does axle move easily with pin and ring installed ?
Are the pin and ring holders bent ?
Unscrew the front of the gun and open carefully. Smell if there is burning, otherwise
clean and replace.
Check the lifting height with the control instrument.
Ground magnet Is the magnet broken ( between the plates) ?
Is the plug well screwed in ?
Make sure the contact surfaces are even.
Electronic units Check cables and connections for play.
Are the contact on the cables damaged ?
Are the knobs loose ?
Are the fuses whole ?
Open the panel, check for a burnt smell, ( the breaker can have burnt out )
Check that cables are attached correctly.
Make a full optical control.
PROBLEM CAUSE SOLUTION
Brazing pin does not ignite
or does not ignite long
enough.
Batteries not charged or are defective.
Test batteries for proper charge. Replace and/or
charge as necessary.
Blown fuse. Check fuses.
Magnetic ground faulty.
Check that surface magnetic ground is applied to
is ground clean. Check magnetic ground cable
and plug for damage.
Faulty cables. Check gun cables and plugs for damage.
Bonding surface contaminated. Check that the brazing surface is ground clean.
Braze is faulty. Batteries not charged or are defective.
Test batteries for proper charge. Replace and/or
charge as necessary.
Incorrect PIN TYPE setting. Check PIN TYPE setting on the control box.
Magnetic ground faulty.
Check that surface magnetic ground is applied to
is ground clean. Check magnetic ground cable
and plug for damage.
Bonding surface contaminated. Check that the brazing surface is ground clean.
Incorrect grinding wheel is used. Use only Tyrolit grinding wheels or carbide burr.
Ceramic ring was not positioned
square to the lug.
Ensure ring is positioned correctly.
Brazing pin not positioned correctly in
lug hole.
Ensure pin is positioned correctly.
EP30250
EP30200
TROUBLESHOOTING