Filter
Top Products
12 ► EP30200 / EP30250 User Manual
- Note that you always must use a railbond together with the brazing pin and the ferrule to do a pin brazing, except
when brazing a special threaded brazing pin then only a ferrule and M8, M10 or M12 brazing pin is to be used.
- Press carefully the gun with the cable shoe, the ferrule and the
brazing pin to the work piece.
- Make sure to braze in the top of the hole
when brazing to a vertical surface.
Brazing.
- Hold the gun rmly with both hands as shown and
pull the trigger just once.
The electronic will by it self nish the brazing process.
- Hold the gun in place for 3-4 sec after the brazing
while the braze freezes.
- Remove the gun straight backwards without
pulling the trigger!
Knock off the shank of the brazing pin.
The brazing is completed.
ACCESSORIES EP300
SEE PAGE 17
Pin holder 8-9,5 mm (A)
Pin holder M8 (B)
Pin holder M10 (C)
Pin holder M12 (D)
Ring holder 8-9,5 mm
Ring holder M8/M10/M12
EP30250 OPERATION