Safety 1st 8047 Baby Monitor User Manual


  Open as PDF
of 7
 
Problem
Possible Cause
Solution
Audio feedback (squealing)
P
arent’s Unit is too close to the Baby’s Unit Move the Parent’s Unit further away from the Baby’s Unit
Lower the volume on the Parent’s Unit
NOTE:
Please do not return this product to the place of purchase. If you are having difficulty using product visit our web site at
www.safety1st.com or contact Consumer Relations at (800) 544-1108.
Power/low battery indicator is
amber
Batteries are low Recharge batteries
Troubleshooting
Parent’s Unit power indicator
does not illuminate
P
arent’s Unit is not turned on
Batteries are dead/Power is turned off
AC Adapter not properly connected
P
ush the button on the front of Parent’s Unit to the on position
Charge battery / Make certain that any light switches that control the power flow to the wall
outlet are on (when using AC).
If batteries are dead, replace battery pack. Contact Consumer
Relations at (800) 544-1108 to order new battery pack.
Check AC Adapter jack-to-socket and plug-to-outlet connections
Power indicator does not
illuminate on Baby’s Unit
Baby’s unit is not turned on
AC Adapter not properly connected
Slide the button on the back of the Baby’s Unit to channel 1, 2 or 3
Make certain that any light switches that control the power flow to the wall outlet are on
(when using AC)
Check AC Adapter jack-to-socket and plug-to-outlet connections
Weak sound coming from
Parent’s Unit
Battery may be low
Baby is too far away from Baby’s Unit
Recharge batteries
Move the Baby’s Unit within 4’ to 6’ of Baby
Parent’s Unit is picking up noises
or displaying interference from
outside your home
Parent’s Unit is picking up noises from outside
your home
Change both the Parent’s and Baby’s Units to an alternate channel (1, 2 or 3)
Parent’s Unit has no
sound/picture or static
Video is not turned on
Volume is too low
Channel switches are not on the same setting
(1, 2 or 3)
Signal interference due to microwaves,
monitors, cellular or cordless telephones, etc.
Out of range
Turn video on at the side of the Parent’s Unit
Adjust the volume control on the Parent’s Unit
Check the channel switches on the Baby’s Unit and Parent’s Unit to confirm they are on
the same channel (1, 2 or 3)
Try one of the other channels
Bring Parent’s Unit closer to Baby’s Unit
6
 previous