Filter
Top Products
Parts List Warnings
Assembly
Care & Maintenance
Replaceable Parts
Warranty
To Use
Contents
Assembly To Use
TM
Install Infant Car Seat
TM TM TM
TM TM TM
TM TM
7
To avoid serious injury:
• Use ONLY Maxi-Cosi
®
Mico
TM
infant car seat with
adapters included with this stroller.
• Please refer to the manufacturer’s instructions
for the use of your infant car seat.
• ALWAYS install car seat facing to the rear of
the stroller.
• ALWAYS use the restraint system in the car
seat.
WARNING
18 Install Infant Car Seat
Push the parking brake pedal down. Remove the seat.
Rotate the pivots so that the two slots are aligned (Figure
18). Be sure that the pivots are in the upright position,
otherwise the adapters will not fit.
Stand at the back of the stroller. Insert the car seat
adapter labeled “R” into right side of the frame until you
hear a “click.” Then insert the car seat adapter labeled
“L” into the left side of the frame until you hear a “click”
(Figure 18a).
Car seat must be positioned so that
child faces the stroller handle.
Lower car seat into car seat adapters until both sides
“click” (Figure 18b).
To remove car seat, press both buttons on car seat
(Figure 18c). Lift car seat up.
To remove car seat adapters, press button and slide
adapter off the frame (Figure 18d).
18a
18b
18d
18c
18
Align
Slots