Filter
Top Products
Quantum 614 Series www.quantumrehab.com 33
VII. CARE AND MAINTENANCE
CARE AND MAINTENANCE
Your Quantum 614 is a sophisticated power chair. Like any motorized vehicle, it requires routine maintenance checks. You can perform
some of these checks, but others require assistance from your Quantum Rehab Provider. Preventive maintenance is very important. If you
follow the maintenance checks in this section as scheduled, you can help ensure that your power chair gives you years of trouble-free
operation. If you have any doubt as to your power chair’s care or operation, contact your Quantum Rehab Provider.
WARNING! Do not service the power chair when the seat is occupied.
Your power chair, like most electrical equipment, is susceptible to damage from the elements. Avoid damp areas of any kind.
WARNING! Direct or prolonged exposure to water or dampness could cause the power
chair to malfunction electronically and mechanically. Water can cause electrical
components to corrode and the chair's frame to rust. Power chairs should be examined
periodically for signs of corrosion caused by water exposure, bodily fluid exposure, or
incontinence. Damaged components should be replaced or treated immediately.
Should your power chair come in contact with water:
1. Dry your power chair as thoroughly as possible with a towel.
2. Allow your power chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.
3. Check the joystick operation and the brakes before using your power chair again.
4. If any inconsistencies are found, take your power chair to an Quantum Rehab Provider. Power chairs that are fre-
quently exposed to sources of water, such as incontinence, should be inspected often for corrosion and electronic
components may need to be replaced frequently.
Temperature
Some of the parts of your power chair are susceptible to extreme changes in temperature. Always keep your power
chair between the temperatures of 18°F (-8°C) and 122°F (50°C).
In extremely cold temperatures the batteries may freeze. The specific temperature at which they freeze depends on a
number of factors, such as battery charge, usage, and composition of the batteries (e.g., AGM or Gel-Cell).
Temperatures above 122°F (50°C) may cause your power chair to operate at a reduced speed. This reduced speed
is a safety feature built into the controller that helps prevent damage to the motor and other electrical components.
General Guidelines
Avoid knocking or bumping the controller, especially the joystick.
Avoid prolonged exposure of your power chair to extreme conditions, such as heat, cold, or moisture.
Keep the controller clean.
Check all connectors to ensure that they are all tight and secured properly.
Maintain but do not exceed the psi/bar/kPa air pressure rating indicated on each tire if equipped with pneumatic tires.
WARNING! Maintain but do not exceed the psi/bar/kPa air pressure rating indicated on each tire if
equipped with pneumatic tires. Do not underinflate or overinflate your tires. Low pressure may
result in loss of control, and overinflated tires may burst. Overinflating tires can cause them to
explode.
WARNING! Do not use a high pressure hose to inflate your tires.
Use a rubber conditioner on the tire sidewalls to help preserve them.
WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may make the
tires slippery and cause your power chair to skid.
All wheel bearings are prelubricated and sealed. They require no subsequent lubrication.