Filter
Top Products
24 www.quantumrehab.com Quantum 614 Series
V. COMFORT ADJUSTMENTS
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to increase
your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller position.
NOTE: If your power chair is equipped with a Synergy Seat or TRU-Balance 2 Power Positioning System,
refer to the seat adjustment information contained in separate manuals. If your power chair is equipped with
a contoured seating system, refer to the following information.
WARNING! The center of gravity of your power chair was factory set to a position that meets the
needs of the demographic majority of users. Your Quantum Rehab Provider has evaluated your power
chair and made any necessary adjustments to suit your specific requirements. Do not change your
seating configuration without first contacting Pride Mobility Products or your Quantum Rehab Provider.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to “Appendix I - Specifications” for specific component weights before you
disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
You may need the following to make comfort adjustments:
metric/standard socket set and ratchet
adjustable wrench
thread lock
Seat Height and Seat Angle Adjustment
You can change the seat height to one of four positions by
raising the front and rear trapeze bars. If you raise or lower
only one trapeze bar (front or rear), you can also change
the seat base angle (dump).
To change the seat height:
1. Turn off the power to the controller.
2. Disconnect the controller connector(s) from the power
base. See figure 7.
3. Flip up the seat latch safety. See figure 12.
4. Squeeze the seat latch and release the seat from the
front trapeze bar.
5. Slide the seat forward and remove it from the power
base.
6. Loosen the setscrews on the seat towers. See figure 13.
7. Loosen the screws that attach the trapeze bars to the
seat posts. See figure 13.
8. Remove the retaining clips that secure the seat posts to
the power base. See figure 13.
9. Move the trapeze bars up or down to the desired height.
NOTE: Change the seat dump by raising or lowering
only one set of towers (front or back).
Figure 13. Seat Adjustment - Trapeze Bars
SEAT POSTS
RETAINING
CLIPS
SCREWS
Figure 12. Seat Height Adjustment - Seat Latch Safety
TRAPEZE BARS
SEAT TOWERS
SETSCREW LOCATION