Filter
Top Products
10
5. Go to File>UpdateKeyboard, Select your interface (USB, AT for PS/2 or Serial
RS232) and click ok to download the file into the keyboard. Wait until the
process is completed.
Figure 7.
6. If the keyboard does not respond to your configuration correctly, change the
speed output by following steps 1 through 5 and select a different speed on
point 4.
DOS PROGRAMMER
1. Connect your keyboard and start DOS programmer
2. Go to the File menu and select “Read keytable”. This command will read all
data and settings that are inside the keyboard. Please, make sure that the
keyboard is connected. A status bar will show you when the reading of the
keyboard has been completed as shown in figure 8.