Filter
Top Products
Menu options
17
Playing lullabies
To play or stop a lullaby:
• Select | , using – and + (B-10).
Confirm by pressing OK (B-7).
• Select : to replay the last played lullaby or <
| to stop playback. Confirm with OK (B-7).
To select a different lullaby:
• Select | , using – and + (B-10).
Confirm by pressing OK (B-7).
• Select ~, using – and + (B-10).
Confirm by pressing OK (B-7).
• Select the desired lullaby, using – and + (B-10).
Confirm by pressing OK (B-7).
Adjusting microphone sensitivity
You can set the sound sensitivity of the baby unit to the desired
level.When set to the maximum sensitivity level all sounds
(including your baby’s breathing, when loud enough) can be
heard on the parent unit.You can only change the microphone
sensitivity if the connection between the baby unit and the
parent unit is established (when LINK lights (A-3, B-3) light
continuously green).
• Select Z , using – and + (B-10).
Confirm by pressing OK (B-7).
• Select the desired sensitivity level for the baby unit
microphone, using – and + (B-10). Confirm with OK (B-7).
ZL = minimum level / lowest sensitivity;
ZLLLLL= maximum level / highest
sensitivity
Note:When the sensitivity level of the baby unit is set to a high
level, the unit will consume power because it is in
continuous transmission mode.
Switching sound alert on and off
If sound alert is switched on, the parent unit beeps as soon as
the fifth sound level light (B-9) lights orange while the volume is
switched off.
• Select X, using – and + (B-10).
Confirm with OK (B-7).
• C or M.
Confirm with OK (B-7).
EN