Filter
Top Products
EN
Getting your baby cam ready
10
4 Slide the battery compartment cover (B-7) back in place.
Push gently until it clicks into position.
5 Pull down the belt clip/support (B-15) slide it upwards until it
clicks into position.
6 Connect the power adapter cord to the unit power supply
jack (DC 8.0V
--<<++
- B-12).
7 Connect the AC power adapter (B-10) to a wall outlet.
Unwrap and fully extend the AC adapter cord.
8 Leave the monitor unit connected to the mains supply until
the batteries are fully charged (at least 10 hours).
> During recharging the POWER light (B-1) blinks red.
> When batteries are fully charged the POWER light (B-1)
lights continuously green.The monitor unit can now be
used cordlessly for at least 3.5 hours.
‹ The monitor unit is now ready for battery-operated
use.
Positioning the monitor unit
• The unit can be placed on a stable, flat surface such as a table
top.
• The belt clip can be used to support the unit in an inclined
position. For this, slide down the belt clip (B-15) and lift it up.
Channel selection
1 Use the CHANNEL selection switch (A-7) on the camera
unit to select the desired channel (1, 2 or 3).
2 Set the CHANNEL selection switch (B-5) on the monitor
unit to the corresponding channel.
• Make sure that both units are always set to the same
channel.